Nose Shower Steamer Mold

This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand.  

The mold contains 1 piece and is available as a single mold to make one bath bomb/shower steamer at a time, or a multi-mold, to make 4 bath bombs/shower steamers at a time. Two design options are available: flat nose and 3D nose.

Colour of mold may vary from photos.

Approximate final bath bomb/shower steamer size:  4.5 cm wide x 5.5 cm tall  x 2.5 cm deep (1.77" wide x 2.16"tall x .98" deep). Flat nose shower steamers in photos weigh approximately 40 grams / 1.41 oz, while the 3D nose shower seteamers in photos weigh approximatly 36g / 1.3 oz .

(Shower steamers not included.)

Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.

Bath Bomb Not Included

This is for a mold only - bath bomb is not included.

Printing Defects

There may be slight discoloration or other printing defects on printed products. This will not affect the performance of the molds.

Cleaning

Rinse your mold under cool water and towel dry to clean mold. Never soak your molds as they can retain water. Do not place your molds in the dishwasher. PLA is susceptible to heat, so please do not use warm or hot water.

Mold Material

Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane.  To clean your mold, rinse under cool water and towel dry.  PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.

How To Use Molds

Place bath bomb/shower steamer mix into mold. Scrape off excess mixture so that the mix is flat (and will be flat when unmolded) - you can use one of our unmolding plates to scrape off the top, or a deli scraper, or any other tool that will scrape off the mix.  Flip mold onto a hard surface (e.g. baking sheet) and lift mold off of bath bomb.  If the mold does not lift off, tap the mold with a spoon or other utensil to tap the bath bomb out of the mold (I usually tap the mold before flipping it).