Macaron Top/Bottom Bath Bomb Mold

This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand.  Use this mold to make the top and bottom of a macaron, then use bubble frosting (after the two halves have dried) to hold them together.   

The mold contains 2 pieces: 1 Base and 1 Top. Color of mold may vary from picture.

Diameter of finished bath bomb is approximately 2".

Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane.  To clean your mold, rinse under cool water and towel dry.  PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.

Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.

To use:  Place bath bomb mix into Base.  Use the Top to press the mix into the Base.  Remove the Top and tap the Base to release the bath bomb.

Bath Bomb Not Included

This is for a mold only - bath bomb is not included.

Printing Defects

There may be slight discoloration or other printing defects on printed products. This will not affect the performance of the molds.

Cleaning

Rinse your mold under cool water and towel dry to clean mold. Never soak your molds as they can retain water. Do not place your molds in the dishwasher. PLA is susceptible to heat, so please do not use warm or hot water.