Cake Pop Bath Bomb Mold

This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand. 

The mold contains 3 pieces: two mold cups and a sleeve.  Mold colour may vary from photo.

Bath bomb in photo weighs approximately 60 g / 2 oz and has about a 4.5 cm/1.75" diameter. (Bath bomb not included).

Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane.  To clean your mold, rinse under cool water and towel dry.  PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.

Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.

To use:  Place one mold cup inside the sleeve.  Add your bath bomb mixture.  Place the other mold cup on top, and then simply press down. You can either push the mold cups out of the sleeve by hand or by using my bath bomb plunger tool.  Next, push a cake pop stick into bath bomb (through opening in mold cups), then take stick out and unmold the bath bomb.  When bath bomb has dried, insert sticks into bath bombs (you can use a melted butter (e.g. cocoa butter) to ensure the stick stays in the bath bomb).

Bath Bomb Not Included

This is for a mold only - bath bomb is not included.

Printing Defects

There may be slight discoloration or other printing defects on printed products. This will not affect the performance of the molds.

Cleaning

Rinse your mold under cool water and towel dry to clean mold. Never soak your molds as they can retain water. Do not place your molds in the dishwasher. PLA is susceptible to heat, so please do not use warm or hot water.