Bowl Bath Bomb Mold

This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand. 

The mold contains 2 pieces.  Mold colour may vary from photo.

Approximate final bath bomb size: 7.5 cm Diameter x 4 cm Deep (3" Diameter x 1.5" Deep). Bath bombs in photos weigh approximately 80 grams / 2.75 oz. (Bath bomb not included.)

Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane.  To clean your mold, rinse under cool water and towel dry.  PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.

Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.

To use:  Add your bath bomb mixture into bottom piece, lightly pressing the mixture against the side of the mold and leaving a hole in the centre.  Place the top piece onto the mold and press down. Using a spoon or other tool, tap the mold to "unsuction" the top piece from the bath bomb. Lift the top piece off, then flip mold onto a tray and tap to release the bath bomb from the mold.

Bath Bomb Not Included

This is for a mold only - bath bomb is not included.

Printing Defects

There may be slight discoloration or other printing defects on printed products. This will not affect the performance of the molds.

Cleaning

Rinse your mold under cool water and towel dry to clean mold. Never soak your molds as they can retain water. Do not place your molds in the dishwasher. PLA is susceptible to heat, so please do not use warm or hot water.